User`s guide

Handling Roll Media – User’s Guide

AP-75100, Rev. 2.0, 26/11/04

Step 3 : Open the front cover.

Step 4 : Put the media roll between the motorized roll unit and roll unit of the unwinder unit.

a. Position in the middle of the printer (use hole pattern in the steel bar).

b. Make sure no slip occurs.

1 : Holes in the steelbar

Step 5 : Install an empty core between the motorized roll unit and roll unit of the winder unit on front of the

printer. -→ Make sure the core is longer then the media width.

Step 6 : Make sure both unwinder (REAR) and winder (FRONT) unit are set to MANUAL mode.

Step 7 : Use the foot-switch to release some media on the rear.

Step 8 : Load media through the rear tensioning system as described below.

1 = Unwinder System 2 = Rear Tension System

3 = Insertion slot

Step 9 : Load the media through the printer’s pressure rollers.

Step 10 : On front of the printer, take the media and pull straight (until you become an equal tension on the

left and right of the media). Do not pull in the middle of the media.