User`s guide

Handling Roll Media – User’s Guide
88
AP-75100, Rev. 2.0, 26/11/04
Step 12 : Insert the adjustment brackets at the left or right side (depending on the deviation) of the winder
system below the rail assembly.
Step 13 : If both lines overlap, calibrations is OK.
Step 14 : Now fix the screws with roll so the rail assy doesn’t move anymore.
Step 15 : Perform the same adjustment procedure for the unwinder at the rear unit.
Step 16 : If this is completed, your calibration of the unwinder/winder 100 is finished.