User`s guide

Handling Roll Media – User’s Guide
86
AP-75100, Rev. 2.0, 26/11/04
4.6.2 Calibration of the front and rear roll unit.
Step 1 : Install a core between the roll unit and the motorized roll unit.
Step 2 : Standing at the front of the unit, use some tape to create a loop with the synthetic paper.
Step 3 : Put the loop around the core installed on to the winder.
Step 4 : Put the pressure rollers in the up position.
Step 5 : Slide the strip forwards.
Step 6 : Standing at the front side of the unit, place the adjustment plate onto the large strip and slide it
against the pressure rollers.