User`s guide

Handling Roll Media – User’s Guide
84
AP-75100, Rev. 2.0, 26/11/04
Step 5 : Standing at the front side of the unit, place the adjustment plate onto the large strip and slide it
against the pressure rollers.
Step 6 : Manually draw a line.
Step 7 : Slide the strip to the left side of the unit. Pull the strip so there is an equal tension.
Step 8 : Manually draw a line. Check if both lines are overlapping.
Step 9 : If not, you have to perform the following adjustment procedure.
Step 10 : Standing at the rear side of the unit, loosen the 4 screws on the right tension bar bracket.