User`s guide

Handling Roll Media – User’s Guide
79
AP-75100, Rev. 2.0, 26/11/04
1 = Rear stop adjustment direction 2 = Rear start adjustment direction
3 = Front stop adjustment direction 4 = Front start adjustment direction
Step 5 : Tighten the start screw on the adjustment lip.
Notes :
¾ If necessary during adjustment, return to the initial speed by toggling the “Automatic”
switch to manual and back.
Notes :
The stop sensor …
¾ … should be covered if the rear tensioning system is horizontal or lower. (Rear
“Automatic” LED is OFF.)
¾ … should be open if the rear tensioning system is horizontal or higher. (Rear
“Automatic” LED is blinking.)
The start sensor …
¾ … should be open if the rear tensioning system has an angle of less than approx.
30°. (Rear “Automatic” LED is blinking.)
¾ … should be covered if the rear tensioning system has an angle of more than
approx. 30°. (Rear “Automatic” LED is ON.)