User`s guide

Handling Roll Media – User’s Guide
40
AP-75100, Rev.2.0, 26/11/04
Step 3 : Rotate the scroller to forward direction by hand, and wind the roll media on the media tube about
one and a half turns.
1. scroller
Step 4 : Set the conditions of the product operation according to the steps in “Operation Panel”.
Step 5 : Load the media and set the media type according to the User’s Guide.
¾ Media loading is completed.
¾ The printer starts printing and the roll media is automatically wound onto the scroller.
3.5.3.2. When winding the media with the printed side inside.
Step 1 : Turn the power ON.
Step 2 : Pull out the roll media from the feed slot of the printer and fix into place with tape so that the
leading edge is parallel with the media tube.
1. Roll media 2. Media tube