User`s guide

Handling Roll Media – User’s Guide
39
AP-75100, Rev.2.0, 26/11/04
3.5. LOADING ROLL MEDIA
3.5.1. Installation of roll media onto the scroller receiver
To install roll media onto the scroller receiver, please refer to the chapter Scroller Receiver”.
3.5.2. Positioning roll media
To position the roll media, please refer to the chapter “Scroller Receiver”.
3.5.3. Attaching roll media to the winder 30
The procedure for attaching roll media to the winder 30 is explained below.
To attach roll media, follow the steps below.
3.5.3.1. When winding the media with the printed side outside.
Step 1 : Turn the power ON.
Step 2 : Pull out the roll media from the feed slot of the printer and fix into place with tape so that the
leading edge is parallel with the media tube.
1. Roll media 2. Media tube