User`s guide

Handling Roll Media – User’s Guide

AP-75100, Rev.2.0, 26/11/04

Step 3 : Attach the scroller receiver to the stand according to the following procedure.

A ) : Attach the scroller receiver to the left side of the stand.

B ) : Using the attached hexagon wrench (diagonal diameter 3 mm), tighten the two hexagon

socket head cap screws (M4x10) to install the scroller receiver.

1. Scroller receiver 2. Stand

3. Hexagon socket head cap screw (M4x10)

C ) : Attach the media tube to the scroller.

D ) : Attach the scroller both to the winder 30 motorized unit and the scroller receiver.

Notes :

• When attaching the scroller to the product, refer to the following diagram and attach

properly. If the direction of the attachment is wrong, the media will not be wound

correctly.

1. Scroller 2. Winder 30 motorized unit

3. Scroller receiver