User`s guide

Handling Roll Media – User’s Guide

AP-75100, Rev.2.0, 26/11/04

Step 2 : Install the media sensor to the stand.

A ) : Attach the media sensor and the two wing bolts (M3x8) at the bottom of the winder 30

motorized unit.

B ) : Tighten the two wing bolts (M3x8) to install the media sensor.

1. Media sensor 2. Winder 30 motorized unit

3. Wing bolt (M3x8)

C ) : Using the attached hexagon wrench (diagonal diameter 3 mm), tighten the two hexagon

socket head cap screws (M4x10) to install the media sensor on the stand.

1. Media sensor 2. Stand

3. Hexagon socket head cap screw (M4x10)

D ) : Connect the media sensor cable to the media sensor connector at the right side of the

roll-up system.

1. Media sensor cable 2. Media sensor connector