User`s guide

Handling Roll Media – User’s Guide

AP-75100, Rev.2.0, 26/11/04

B ) : Using the attached hexagon wrench (diagonal diameter 3 mm), tighten the two hexagon

socket head cap screws (M4x10) to install the scroller receiver.

1. Scroller receiver 2. Stand

3. Hexagon socket head cap screw (M4x10)

C ) : Attach the media tube to the scroller.

D ) : Install the scroller onto the scroller receiver and winder 30 motorized unit.

Notes :

• When attaching the scroller to the product, refer to the following diagram and

attached properly. If the direction of the attachment is wrong, the media will not be

wound correctly.

1. Scroller 2. Winder 30 motorized unit

3. Scroller receiver

E ) : Adjust the position of the scroller receiver as such that the scroller is positioned in

parallel with the stand; in other words, the distance between the stand and the scroller,

referred as L in the diagram, is equal on the right and left side.

1. Scroller 2. Stand

3. Scroller receiver

F ) : Install the scroller receiver as in step B.

Step 4 : Installation of the winder 30 has been completed.