User`s guide

Handling Roll Media – User’s Guide

AP-75100, Rev.2.0, 26/11/04

B ) : Tighten the two wing bolts (M3x8) to install the media sensor.

1. Media sensor 3. Wing bolt (M3x8)

2. Winder 30 motorized unit

C ) : Using the attached hexagon wrench (diagonal diameter 3 mm), tighten the two hexagon

socket head cap screws (M4x10) to install the media sensor to the stand.

1. Media sensor 3. Hexagon socket head cap screw (M4x10)

2. Stand

D ) : Connect the media sensor cable to the media sensor connector on the right side of the

winder 30 motorized unit.

1. Media sensor cable 2. Media sensor connector

Step 3 : Attach the scroller receiver to the stand according to the following procedure.

A ) : Attach the scroller receiver to the left side of the stand.