User`s guide

Handling Roll Media – User’s Guide
20
AP-75100, Rev.2.0, 26/11/04
Step 8 : While holding down the end of the media, hold the scroller and roll out a bit of media. Remove
slack and skewness, then align the right edge of the roll media parallel with the media loading
position.
1. Scroller 2. Media loading position
Notes :
• The media loading position is a guideline for setting up the media.
• If the right edge of the roll media is 5 mm or more from the media setting position, a
media set error may result if the media is not detected. Make sure to set the right
edge of the roll media within 5 mm of the media setting position.
• If it is not possible to set the right edge of the roll media within 5 mm of the media
setting position, refer to the figure below and set the scroller position.
• If the right edge of roll media is not in line with the Media loading position, adjust
the scroller position as shown below.
When moving the roll media to the left
¾ Rotate the scroller adjustment screw counterclockwisely.
1. Scroller adjustment screw 2. Scroller
3. Roll media 4. Media loading position