User`s guide

Handling Roll Media – User’s Guide
15
AP-75100, Rev.2.0, 26/11/04
2.4. INSTALLATION OF ROLL MEDIA ONTO THE SCROLLER
RECEIVER
The procedure for installation of roll media onto the scroller receiver is explained below.
Notes :
• You can attach roll media with a 2 inch (outer diameter: 103 mm or smaller; weight
maximum 30 kg) or 3 inch media tube (outer diameter: 150 mm or smaller; weight
maximum 30 kg) to your printer. Please note that for the 87” model only a 3”
scroller is available.
To attach roll media, follow the steps below.
Caution :
• When setting roll media, place it on top of a desk or other flat surface.
• Position the roll media in such way that finally, the printing side will be “upside” in
the printer.
• Setting roll media with the scroller standing up may damage them.
Step 1 : Slide and remove the movable flange from the scroller.
1. Scroller 2. Movable flange
Step 2 : When using roll media with a media tube diameter of 2 inches, remove the movable flange and
the fixed flange adapter.
1. Movable flange 2. Fixed flange
3. Adapter