Technical information

TIB219_Rockhopper II_FW rh3.00 Page 9/11
2.3. Start printing while waiting for heaters
A new option called "PrintStart" is available in the Heater status menu while the printer is waiting for the
heaters to warm up before printing starts. When you choose this option, printing will start immediately.
However, the heaters will continue to warm up in order to reach the requested temperature.
Notes
• For the best printing output it is recommended to let your heaters warm up to the requested
temperature before you start printing.
2.4. Utility Æ Slant check
It is possible to switch slant check detection ON or OFF (default: ON)
The Slantcheck setting is added to the utility section of the setup list.