Specifications

Rockhopper II series printers – Maintenance Manual

AP-74065, Rev. 1.2, 27/09/04

Step 1 : Remove the 2 screws fixing the cutter holder and holder support.

1 = Holder support 2 = Cutter holder

3 = Screws (M3x6) fixing the cutter holder and holder support

Step 2 : Remove the cutter holder.

Step 3 : Remove the cutter blade and cutter spring from the cutter holder.

Step 4 : Remove the cutter cap and Solenoid spring.

Step 5 : Remove the screw fixing the solenoid assembly to the cutter cap.

1 = Cutter cap 2 = Screws (M3x6) fixing the solenoid assembly to

the cutter cap

3 = Solenoid spring 4 = Solenoid assembly

5 = Screws (M2x4) fixing the solenoid assembly to

the cutter holder

6 = Cutter holder

Step 6 : Replace the cutter cap and solenoid spring.

Step 7 : Remove the 2 screws fixing the solenoid assembly to the cutter holder.

Step 8 : Use a screwdriver to push the solenoid assembly up from the hole on the cutter holder side.

Step 9 : Replace the solenoid assembly.

Step 10 : Reinstall all parts in the opposite order of the removal procedure.

Step 11 : Adjust the cutter according to "Cutter adjustment".