Specifications

Rockhopper II series printers – Maintenance Manual

AP-74065, Rev. 1.2, 27/09/04

4.6.8. Replace the cover R sensor assembly and the cover L sensor

assembly

Notes :

¾ Remove following covers before replacing the cover R sensor assembly and the

cover L sensor assembly.

 Side cover R: refer to "Removing side cover R"

 Side cover L: refer to "Removing side cover L"

 Front cover: refer to "Removing the front cover"

 Carriage cover: refer to "Removing the carriage cover"

 Y rail cover: refer to "Removing the Y rail cover"

(1) Replacing the cover R sensor assembly

Step 1 : Remove the cover R sensor assembly connector from the Mainboard assembly.

Step 2 : Remove the 2 screws fixing the cover R sensor assembly.

1 = Cover R sensor assembly 2 = Screws (M2x8) fixing the cover R sensor assembly

Step 3 : Replace the cover R sensor assembly.

Step 4 : Reinstall all parts in the opposite order of the removal procedure.

Step 5 : Perform cover sensor adjustment according to "Cover sensor adjustment".

(2) Replacing the cover L sensor assembly

Step 1 : Remove media guide F.

Step 2 : Remove the cover L sensor assembly connector from the cover L cable.

Step 3 : Remove the 2 screws fixing the cover L sensor assembly.

1 = Cover L sensor assembly 2 = Screws (M2x8) fixing the cover L sensor assembly

Step 4 : Replace the cover L sensor assembly.

Step 5 : Reinstall all parts in the opposite order of the removal procedure.

Step 6 : Perform cover sensor adjustment according to "Cover sensor adjustment".