Specifications

Rockhopper II series printers – Maintenance Manual

AP-74065, Rev. 1.2, 27/09/04

Step 5 : Completely remove tube bundles 1 and 2.

1 = Tube bundle 2 = Tube bundle 2

Step 6 : Remove the 4 screws fixing the tube clamp.

Step 7 : Remove the tube clamp.

Step 8 : Remove the coupling screws, O-ring and ink tube from the coupling.

Step 9 : Replace the ink tube.

Step 10 : Remove the 2 screws fixing the cable clamp.

Step 11 : Replace the steel bearing.

Step 12 : Replace the tube guide.

Step 13 : Remove the pipe clamp.

Step 14 : Replace the CR tape power cable.

1 = Tube push plate 2 = Cable clamp

2 = Pipe clamp 3 = Coupling, O-ring, coupling screws

4 = Screws fixing tube push plate (M3x8) 4 = Screws fixing tube cramp (M3x20)

Step 15 : Reinstall all parts in the opposite order of the removal procedure.

Notes :

¾ The CR tape power cables must be bundled during installation so that they can not

move.

¾ The edge of the tube push plate must be upside when installed.

¾ You should soak the O-ring in cleaning liquid once gain before installing it.