Specifications

Rockhopper II series printers – Maintenance Manual

AP-74065, Rev. 1.2, 27/09/04

4.6.7. Replacing the steel bearer, tube guide, CR tape power cable and

ink

tube

Notes :

¾ To replace the board and connect or disconnect the FFC type cable, you should

leave the plug disconnected from the power socket for a while. Otherwise, over-

current could be generated and damage board.

¾ Remove following covers before replacing the steel bearer, tube guide, CR tape

power cable, and ink tube.

 Side cover R: refer to "Removing side cover R"

 Side cover L: refer to "Removing side cover L"

 Front cover: refer to "Removing the front cover"

 Carriage cover: refer to "Removing the carriage cover"

 Y rail cover: refer to "Removing the Y rail cover"

Step 1 : Remove the 8 screws fixing the CR cover.

1 = CR cover 2 = Screws (M3x8) fixing the CR cover

Step 2 : Remove the CR tape power cable connector from the CR board assembly and Mainboard

assembly.

Step 3 : Remove the 2 screws fixing cable push plate.

Step 4 : Remove the 2 screws fixing the tube clamp.

1 = CR tape power cable 2 = Steel bearer

3 = Cable push plate 4 = Screws fixing cable push plate (M3x8)

5 = Screws fixing tube clamp (M3x8)