Specifications

Rockhopper II series printers – Maintenance Manual

AP-74065, Rev. 1.2, 27/09/04

(2) Replacing the transmission photosensor (CR origin side)

Notes :

¾ Refer to ‘Head Lock Menu’

Step 1 : Unlock the head.

Step 2 : Move the carriage from the capping position to the left.

Step 3 : Remove the transmission photosensor from the ORG sensor installation board.

1 = ORG sensor installation board 2 = Connector

3 = Transmission photosensor

Notes :

¾ The ORG sensor installation board has been adjusted at the origin in factory. Do

not loosen the fixed screws.

Step 4 : Remove the connector from the transmission photosensor.

Step 5 : Remove the transmission photosensor.

Step 6 : Apply the screw lock to the tab portions of the transmission photosensors to be installed.

Step 7 : Reinstall all parts in the opposite order of the removal procedure.