Specifications

Rockhopper II series printers – Maintenance Manual

AP-74065, Rev. 1.2, 27/09/04

4.5.7. Replacing the lever motor assembly and the arm motor

installation

board

Caution :

The motor is hot after the product has been operated, so be careful not to burn yourself.

Notes :

¾ Remove following covers before replacing the lever motor.

 Side cover R: refer to "Removing side cover R"

 Side cover L: refer to "Removing side cover L"

 Front cover: refer to "Removing the front cover"

 Carriage cover: refer to "Removing the carriage cover"

 Y rail cover: refer to "Removing the Y rail cover"

 Media guide F: refer to "Removing media guide F"

Step 1 : Remove the lever motor assembly connector.

Step 2 : Remove the screw fixing the sensor installation board.

1 = Sensor installation board 2 = Screw (M3x8) fixing the sensor installation board

Step 3 : Remove the sensor installation board.

Step 4 : Remove the hexagon socket head screws with spring washers (3) fixing the CR motor assembly

to the arm motor installation board.

1 = Lever motor assembly 2 = Hexagon socket head screws with spring

washers (M4x10)