Specifications

Rockhopper II series printers – Maintenance Manual

AP-74065, Rev. 1.2, 27/09/04

4.5.5. Replacing the P_REAR_R sensor assembly and P_REAR_L

sensor

assembly

Notes :

¾ Remove following covers before replacing the P_REAR_R sensor assembly and

P_REAR_L sensor assembly.

 Side cover R: refer to "Removing side cover R"

 Side cover L: refer to "Removing side cover L"

 Front cover: refer to "Removing the front cover"

 Carriage cover: refer to "Removing the carriage cover"

 Y rail cover: refer to "Removing the Y rail cover"

 Media guide F: refer to "Removing media guide F"

Step 1 : Remove the connectors for the P_REAR_R sensor assembly and P_REAR_L sensor assembly

from the Mainboard assembly.

Step 2 : Remove the screw fixing the media sensor installation board.

1 = Media sensor installation board 2 = Screw (M3x8) fixing the media sensor installation board

Step 3 : Remove the media sensor installation board.

Step 4 : Remove the 2 screws fixing the P_REAR_R sensor assembly.

1 = P_REAR_R sensor assembly 2 = Screws (M2x5) fixing the P_REAR_R sensor assembly

Step 5 : Replace the P_REAR_R sensor assembly.

Step 6 : Use the same procedure to replace the P_REAR_L sensor assembly.

Step 7 : Reinstall all parts in the opposite order of the removal procedure.