Specifications

Rockhopper II series printers – Maintenance Manual

AP-74065, Rev. 1.2, 27/09/04

Step 13 : Stick the isolation tape onto the heater strips.

1 = plot platform 2 = fixer heater strip

3 = isolation tape

Step 14 : Reinstall all parts in the opposite order of the removal procedure.

Notes :

¾ During reinstallation of the plate, make sure there are no cables stuck.

4.3.2.4. Replacing the heater (Heater A) on a Rockhopper II 4H printer

Before replacing the post fixer, make sure to have following items:

¾ 50” model : Heater A 50

¾ 64” model : Heater A 64

¾ 87” model : Heater A 87

¾ 2 x press plate

¾ Silicone glue

To replace the heater on a Rockhopper II 4H printer, please follow the instructions mentioned below.

Step 1 : Remove side cover L.

Step 2 : Remove side cover R.

Step 3 : Remove the front cover.

Step 4 : Remove the Y rail cover.

Step 5 : Remove the rear paper guide.

Step 6 : Remove the heater strip.

Step 7 : Degrease the plate.

Notes :

¾ Make sure the plate is cleaned properly. Dust, glue and other parts must be

removed.