Specifications

Rockhopper II series printers – Maintenance Manual

AP-74065, Rev. 1.2, 27/09/04

Step 9 : Stick onto the sensor a sensor insul. patch.

1 = sensor insul. patch 2 = assembly hole

Step 10 : Reinstall all parts in the opposite order of the removal procedure.

Notes :

¾ During reinstallation of the plate, make sure there are no cables stuck.

4.3.2.3. Replacing the fixer (Heater B1 and Heater B2) on a Rockhopper II 4H printer

Before replacing the fixer, make sure to have following items:

¾ 50” model : Fixer B1 50 and Fixer B2 50

¾ 64” model : Fixer B1 64 and Fixer B2 64

¾ 87” model : Fixer B1 87 and Fixer B2 87

¾ Isolation tape

¾ Plot platform calibre

To replace the fixer on a Rockhopper II 4H printer, please follow the instructions mentioned below.

Step 1 : Remove side cover L.

Step 2 : Remove side cover R.

Step 3 : Remove the front cover.

Step 4 : Remove the Y rail cover.

Step 5 : Remove the front paper guide.

Step 6 : Place the plot platform calibre onto the plot platforms.

1 = plot platforms 2 = plot platform calibre onto the plot platforms