Specifications

Rockhopper II series printers – Maintenance Manual

AP-74065, Rev. 1.2, 27/09/04

Step 10 : Reinstall all parts in the opposite order of the removal procedure.

Notes :

¾ During reinstallation of the plate, make sure there are no cables stuck.

4.3.2.2. Replacing the post fixer (Heater C) on a Rockhopper II 4H printer

Before replacing the heater, make sure to have following items:

¾ 50” model : Post Fixer C 50

¾ 64” model : Post Fixer C 64

¾ 87” model : Post Fixer C 87

¾ 1 x sensor insul. Patch

To replace the post fixer on a Rockhopper II 4H printer, please follow the instructions mentioned below.

Step 1 : Remove side cover L.

Step 2 : Remove side cover R.

Step 3 : Remove the front cover.

Step 4 : Remove the Y rail cover.

Step 5 : Remove the front paper guide.

Step 6 : Remove the post fixer strip.

Step 7 : Degrease the plate.

Notes :

¾ Make sure the plate is cleaned properly. Dust, glue and other parts must be

removed.

Step 8 : Stick the post fixer strip onto the plate.

Notes :

¾ Make sure that the strips connect properly.

¾ Stick it as close as possible to the assembly holes. Make sure it does not touch the

assembly holes.

Notes :

¾ Please make sure that there are no air bubbles under the heater strip. Air bubbles

below the heater strip could cause overheating of the heater strip.