Specifications

Rockhopper II series printers – Maintenance Manual
57
AP-74065, Rev. 1.2, 27/09/04
4.3.1.2. Replacing the rear heater on a Rockhopper II printer
Before replacing the post fixer, make sure to have following items:
¾ 50” model : Heater strip assy rear 50
¾ 64” model : Heater strip assy rear 64
¾ 87” model : Heater strip assy rear 87
¾ 2 x press plate
¾ Silicone glue
To replace the rear heater on a Rockhopper II printer, please follow the instructions mentioned below.
Step 1 : Remove side cover L.
Step 2 : Remove side cover R.
Step 3 : Remove the front cover.
Step 4 : Remove the Y rail cover.
Step 5 : Remove the rear paper guide.
Step 6 : Remove the rear heater strip.
Step 7 : Degrease the plate.
Notes :
¾ Make sure the plate is cleaned properly. Dust, glue and other parts must be
removed.
Step 8 : Stick the rear heater strip onto the plate.
Step 9 : Stick (with silicone glue) the two press plates onto the heater strip.
¾ 50” model : X = 380 mm
¾ 64” model : X = 380 mm / Y = 1060 mm
¾ 87” model : X = 660 mm / Y = 1200 mm / Z = 1750 mm