Specifications

Rockhopper II series printers – Maintenance Manual
56
AP-74065, Rev. 1.2, 27/09/04
Step 7 : Remove the front heater strip(s).
Step 8 : Degrease the plate.
Notes :
¾ Make sure the plate is cleaned properly. Dust, glue and other parts must be
removed.
Step 9 : Stick the front heater strip(s) onto the plate.
Notes :
¾ Make sure that the strips connect properly.
¾ Please make sure that the sensor (blue blocks) are positioned on the flat surface of
the front paper guide.
Notes :
¾ Please make sure that there are no air bubbles under the heater strip. Air bubbles
below the heater strip could cause overheating of the heater strip.
Step 10 : Stick onto the sensor an isolation strip.
Step 11 : Reinstall all parts in the opposite order of the removal procedure.
Notes :
¾ During reinstallation of the plate, make sure there are no cables stuck.