Specifications

Rockhopper II series printers – Maintenance Manual

AP-74065, Rev. 1.2, 27/09/04

4.2.10. Removing the head cover

Step 1 : Remove the I/H cover.

Step 2 : Remove side cover R.

Step 3 : Remove side cover L.

Step 4 : Remove the front cover.

Step 5 : Remove the carriage cover.

Caution :

Please note that this cover is only on a Rockhopper II (2 heaters) printer.

Step 6 : Remove the Y rail cover.

Step 7 : Unlock the head.

Notes :

¾ Please refer to the ‘Head lock menu’.

Step 8 : Pull the head out to the left of the maintenance station.

Caution :

When pulling the head out, do not press on the cutter cap. Doing so could damage the

cutter blade.

Step 9 : Remove the 2 screws fixing the head cover.

1 = Screws (M3x8) fixing the head cover

Step 10 : Remove the head cover.

Step 11 : Replace the parts inside the printer.

Step 12 : Reinstall all parts in the opposite order of the removal procedure.