Specifications

Rockhopper II series printers – Maintenance Manual

AP-74065, Rev. 1.2, 27/09/04

4.2.7. Removing the Y rail cover

Caution :

Removing the Y rail cover, should be performed by at least two persons.

Otherwise the Y rail cover may be deformed.

Step 1 : Remove side cover R.

Step 2 : Remove side cover L.

Step 3 : Remove the front cover.

Step 4 : Remove the carriage cover.

Caution :

Please note that this cover is only on a Rockhopper II (2 heaters) printer.

Step 5 : Remove the 3 screws fixing the Y rail cover and the Y rail cover FG.

1 = Y rail cover FG 2 = Screws (M3x6) fixing the Y rail cover and the Y rail cover FG

Step 6 : Remove the 6 screws from the front of the Y rail cover.

1 = Screws (M4x8) on the front of the Y rail cover