Specifications

Rockhopper II series printers – Maintenance Manual
312
AP-74065, Rev. 1.2, 27/09/04
b) It does not move up or
down.
• The connectors
may have poor
contacts.
Check the
connections of the
following
connectors.
• CR board : J235
• CR board : J201-
J216
• Mainboard : J137-
J152
→ Replacing the CR
board assembly
→ Replacing the
Mainboard
assembly,
HDD_Extension
board assembly,
HEAD_DRV board
assembly and
cooling fan
assembly
(8) Open CR cable, faulty
solenoid assembly, faulty
board assembly, etc. may be
the causes.
• Replace the CR
tape power cables.
• Replace the
solenoid assembly
• Replace the CR
board assembly
• Replace the
Mainboard
assembly
→ Replacing the
steel bearer, tube
guide, CR tape
power cable and ink
tube.
→ Replacing the
cutter holder, cutter
spring, cutter cap,
solenoid assembly
and solenoid spring.
→ Replacing the CR
board assembly
→ Replacing the
Mainboard
assembly,
HDD_Extension
board assembly,
HEAD_DRV board
assembly and
cooling fan
assembly
(1) Check if the paper (output)
size on the application side is
correct.
• Correct the paper
(output) size on the
application side.
-
(2) The program ROM may
have failed.
• Upgrade the
firmware version.
→ Firmware
installation
(3) Check the CR cables for
skewed insertion.
• Check the
connections of the
following
connectors.
• CR board : J235
• CR board : J201-
J216
• Mainboard : J137
– J152
→ Replacing the CR
board assembly
(4) The CR board may have a
problem.
• Replace the CR
board.
→ Replacing the CR
board assembly
2 Cutting has been
performed during
printing.
(5) The Mainboard may have a
problem.
• Replace the
Mainboard .
→ Replacing the
Mainboard
assembly,
HDD_Extension
board assembly,
HEAD_DRV board
assembly and
cooling fan
assembly