Specifications

Rockhopper II series printers – Maintenance Manual
275
AP-74065, Rev. 1.2, 27/09/04
(2) The number of
times the print
head was used
reached the
maximum
allowable times.
• Replace the print
head assembly.
• Initialize the head
unit.
→ Replacing the
print head
assembly and
head tape power
cable.
→ Counter
initialization
menu.
(3) If initialization
does not take
effect when the
head unit is
initialized, the
Mainboard
assembly may be
damaged.
• Replace the
Mainboard
assembly.
→ Replacing the
Mainboard
assembly,
HDD_Extension
board assembly,
HEAD_DRV
board assembly
and cooling fan
assembly
(1) Check the
connections of
connectors.
• Redo the
connections of the
following
connectors.
• Mainboard : J102
• power source
board (small)
assembly : CN51 –
CN52
(2) The
HDD_MOTHER
board assembly
may be damaged.
• Replace the ink
tube.
• Initializing CR
motor history.
(3) Hard disk may
be damaged.
• Replace the hard
disks.
11 Hard disk
status connect
error
There is a problem
in the hard disk
connections.
(4) The Mainboard
assembly may be
damaged.
• Replace the
Mainboard
assembly.
→ Replacing the
Mainboard
assembly,
HDD_Extension
board assembly,
HEAD_DRV
board assembly
and cooling fan
assembly.
→ Replacing the
power source
board assembly.
(1) The
PCI_LINUX board
assembly may be
damaged.
• Replace the
PCI_LINUX board
assembly.
12 Network
initialize error
There is a problem
in the network
board.
(2) The Mainboard
assembly may be
damaged.
• Replace the
Mainboard
assembly.
→ Replacing the
Mainboard
assembly,
HDD_Extension
board assembly,
HEAD_DRV
board assembly
and cooling fan
assembly.
(1) Check if the
waste bottle has
been installed.
• Install the waste
bottle correctly.
- 13 Waste ink tank
sts. No
The waste tank is
not installed.
(2) Check the
operation of the
waste box sensor
assembly via
“Sensor/Waste
Bin” of the self-
diagnostic
function.
• Replace the
waste box sensor
assembly.
-