Specifications

Rockhopper II series printers – Maintenance Manual
195
AP-74065, Rev. 1.2, 27/09/04
5.9.10. Endurance Running Check Menu
In this menu, you can confirm the number of endurance running cycles that have been already finished.
The number of endurance running cycles is stored in NVRAM in the system. Therefore, even if a serious
error occurs during endurance running, you can confirm the number of finished cycles just before the
occurrence of the serious error.
* Check *
CR Motor 50 Number of endurance running cycles (CR Motor)
PF Motor 0 Number of endurance running cycles (PF Motor)
(1/5)
* Check *
Cutter 33 Number of endurance running cycles (Cutter)
Head U/D 55 Number of endurance running cycles (Head
(2/5) up/down)
* Check *
Head lock 77 Number of endurance running cycles (head lock)
Wiper 77 Number of endurance running cycles (wiper)
(3/5)
* Check *
Pump 77 Number of endurance running cycles (pump mot)
Lever Motor 77 Number of endurance running cycles (sequential
(4/5) Printing)
* Check *
Nozzle 77
Total Life 88 Number of endurance running cycles (All)
(5/5)