Specifications

Rockhopper II series printers – Maintenance Manual
191
AP-74065, Rev. 1.2, 27/09/04
5.9.6. Pump Endurance menu
This menu performs endurance running for the pump.
In the Pump Endurance menu, you can perform the pump motor assembly endurance operation according to
the settings.
The available settings are shown below.
Setup item Description Parameters Remarks
Operation speed Sets the operation speed
of the pump motor
assembly.
High/Normal/Low
Number of endurance
running cycles
Set the number of
endurance running
cycles
-1 to 10000
Notes :
¾ If the number of endurance running cycles is set to -1, the units continuously repeat
endurance running until a key input is given from the operation panel.
¾ The maximum counter value for endurance running cycles is 99999999 (up to 8-digit
number). If the number of cycles exceeds the maximum value, the counter is reset
to 0.
* Aging pump *
F1 →
High Normal
← F2
F3 →
Low
↓ Select speed (high)
* LifeCount *
Count
-1 → 10000 +
Number of endurance running cycles
50 -
↓ ENTER
* High *
Count 5 Perform endurance running
↓ ENTER or CANCEL
* High *
End 50