Specifications

Rockhopper II series printers – Maintenance Manual
189
AP-74065, Rev. 1.2, 27/09/04
* Cutter *
Count 5 Perform endurance
↓ ENTER
* Cutter *
End 50
5.9.4. Head Up/Down Endurance Menu
This menu performs endurance running for the head up/down operation.
You can perform the capping operation according to your desired settings. The available settings are shown
below.
Setup item Description Parameters Remarks
Waiting time Set the waiting time after one
cycle of endurance running
10 Unit: second
Number of endurance
running cycles
Set the number of endurance
running cycles
-1 to 10000
Notes :
¾ If the number of endurance running cycles is set to -1, the units continuously repeat
endurance running until a key input is given from the operation panel.
¾ The maximum counter value for endurance running cycles is 99999999 (up to 8-digit
number). If the number of cycles exceeds the maximum value, the counter is reset to 0.
¾ The waiting time is not modifiable.
* LifeCount *
Count
-1 → 10000 +
Number of endurance running cycles
50 -
↓ ENTER
* Head U/D *
Time Wait (sec) 10 Check wait time
↓ ENTER or CANCEL
* Head U/D *
Count 5 Perform endurance running
↓ ENTER or CANCEL
* Head U/D *
End 50