Specifications

Rockhopper II series printers – Maintenance Manual
150
AP-74065, Rev. 1.2, 27/09/04
5.5. ADJUSTMENT MENU
In this menu, you can align the printing position and correct the media feed operation.
The Adjustment menu includes following diagnosis menus :
Initialization item Description Refer to
Skew check In this menu, you can perform media feed and check
the degree of skew in the media feed operation by
means of the sensors.
Skew Check Menu
Head rank input Inputs the characteristic value of the installed print
head. Ink is replenished after this input.
Head rank input menu
Head nozzle check Prints out a printing to check the ink discharge
performance of the head nozzles.
Head Nozzle Check Menu
Head angle check Prints out a print to check for printer head slant.
Mechanical adjustment should be performed as
necessary.
Head Slant Check Menu
Repeatability
adjustment
Prints out a print to align the two-way printing
position.
Repeatability Adjustment
Menu
CW adjustment Prints out a print to adjust any gaps between the
heads.
CW Adjustment Menu
Band feed correction Prints out a print to correct the media feed amount
for each pass.
Band Feed Correction
Menu (X Length)
Top & bottom
adjustment
Sets the top and bottom margins. Top & bottom adjustment
menu
P_REAR sensor
position adjustment
Adjusts the position of the P_REAR sensor using
sheet media.
P_REAR sensor position
adjustment menu
Test Print Prints out a nozzle check pattern and the adjustment
variables.
Test print menu
Head Wash Cleans the tubes and heads using cleaning fluid. Head wash menu
Software counter
initialization
Clears various software counters. Software Counter
Initialization Menu
Feed amount check Used to check the media feed amount for one band. Feed Pitch Check Menu
Fill pattern A fill printing pattern is printed by both ends of the
head.
Fill printing menu
* Adj *
F1 →
CheckSkew Input Rank
← F2
F3 →
ChkNozzle HeadSlant
← F4
(1/4)
* Adj *
F1 →
Bi-D Uni-D
← F2
F3 →
Feed Adj. Top&Bottom
← F4
(2/4)
* Adj *
F1 →
R. Sns. Pos. TestPrint
← F2
F3 →
CleanHead CountClear
← F4
(3/4)
* Adj *
F1 →
SendPitch
F3 →
FillPattern
(4/4)