Specifications

Rockhopper II series printers – Maintenance Manual
145
AP-74065, Rev. 1.2, 27/09/04
5.4.4. Sensor Menu
This menu displays the sensor status in the operation panel.
If the displayed sensor status does not match the actual machine status, replace or adjust the relevant
sensor referring to "Table Inspection Items in Sensor Menu".
N° Sensor name Status in display Refer to
CR_HP sensor ON/OFF Replacing the transmission photosensor
Waste fluid sensor ON/OFF Replacing the waste liquid BOX sensor assembly
Cover sensor Open/Close Replace the cover R sensor assembly and the
cover L sensor assembly
Ink cover sensor Open/Close Removing the I/H cover
Lever Up ON/OFF Replacing the transmission photosensor
Lever Down ON/OFF Replacing the transmission photosensor
Foot lever SW sensor ON/OFF
P_EDDE sensor 0 to FF (0 to 255) Replacing the P_EDGE sensor assembly
P_REAR-R sensor ON/OFF Replacing the P_REAR_R sensor assembly and
P_REAR_L sensor assembly
P_REAR-L sensor ON/OFF Replacing the P_REAR_R sensor assembly and
P_REAR_L sensor assembly
HD_SLIDE sensor ON/OFF Replacing the SLIDE motor assembly, HD_SLIDE
sensor assembly and slide motor installation board
Head thermister **°C
Ink ID sensor Pig, Dye, WASH Replacing the Cartridge Area
Ink NOT sensor 12345678 Replacing the Cartridge Area
Ink END sensor 12345678 Replacing the Cartridge Area
Notes :
¾ The ink ID sensor indicates the type of ink cartridge installed with the following ID.
• W(ASH): Cleaning fluid
• P(ig): Pigment system ink
• D(ye): Dye system ink
• + : Eco Solvent Plus
¾ The ink NOT sensor indicates the number where a cartridge is missing.
¾ For the ink end sensor, the colour of the ink that has run out is displayed.
* Sensor *
CR Origin Off CR_HP sensor
Waste Bin On Waste fluid sensor
(1/9)
* Sensor *
Wiper On Wiper sensor
Cap Off Cap sensor
(2/9)
* Sensor *
Cover Open Cover sensor
InkCover Open Ink cover sensor
(3/9)
* Sensor *
LeverUp On Lever up sensor
LeverDown On Lever down sensor
(4/9)