Specifications

Rockhopper II series printers – Maintenance Manual
112
AP-74065, Rev. 1.2, 27/09/04
4.8. REPLACING THE MAINTENANCE AREA
4.8.1. Replacing the maintenance assembly
Notes :
¾ When replacing the parts inside the maintenance assembly, be sure to perform
following operation to clear the counter.
 "High ink initialization" or " Cleaning initialization": refer to "Counter Display
Menu"
¾ Remove following covers before replacing the parts inside the maintenance
assembly.
 Side cover R: refer to "Removing side cover R"
 Side cover L: refer to "Removing side cover L"
 Front cover: refer to "Removing the front cover"
 Carriage cover: refer to "Removing the carriage cover"
 Y rail cover: refer to "Removing the Y rail cover"
Step 1 : Follow step 1 in "Replacing the flushing box assembly" to move the CR cursor to the left.
Step 2 : Remove the 4 screws fixing the side plate T.
1 = Side plate T 2 = Screws (M3x6) fixing the side plate T
Step 3 : Remove the side plate T.
Step 4 : Remove the screw fixing the waste fluid receptacle.
Step 5 : Remove the waste fluid receptacle.
Step 6 : Remove the screw fixing the flushing box installation board.
Step 7 : Remove the flushing box installation board.