Specifications

Rockhopper II series printers – Maintenance Manual
110
AP-74065, Rev. 1.2, 27/09/04
4.7.9.3. B. Replacing the cursor roller assembly (6 high-load bearings) : open bearing type
Step 1 : Follow the instructions in "Replacing the CR cursor assembly " to remove the CR cursor
assembly.
Step 2 : Remove the side cursor roller assemblies and B cursor axises together with flat-head driver or
another tool.
1 = CR cursor assembly 2 = B cursor axis
Step 3 : Remove the E ring fixing the cursor roller assembly (MY-43272) of downside.
1 = CR cursor assembly 2 = E ring fixing the cursor roller assembly.
Step 4 : Replace the cursor roller assembly.
Step 5 : Install the spacers and the other parts as shown in the following figure.
1 = E ring fixing the side cursor roller assy 2 = Spacer of the side cursor roller assy
3 = High-load bearing of the side cursor roller assy 4 = Spacer of the side cursor roller assy
5 = Brass spacer of the side cursor roller assy 6 = E ring of the cursor roller assy
7 = Spacer of the cursor roller assy 8 = High-load bearing of the cursor roller assy of
downside
9 = Spacer of the cursor roller assy 10 = Brass spacer of the cursor roller assy