Specifications

Rockhopper II series printers – Maintenance Manual
104
AP-74065, Rev. 1.2, 27/09/04
4.7.6. Replacing the P_EDGE sensor assembly
Notes :
¾ Remove following covers before replacing the P_EDGE sensor Assembly.
 Side cover R: refer to "Removing side cover R"
 Side cover L: refer to "Removing side cover L"
 Front cover: refer to "Removing the front cover"
 Carriage cover: refer to "Removing the carriage cover"
 Y rail cover: refer to "Removing the Y rail cover"
 Head cover: refer to "Removing the head cover"
Step 1 : Remove the P_EDGE sensor assembly connector from the CR board assembly.
Step 2 : Remove the screw fixing the P_EDGE sensor assembly.
Step 3 : Replace the P_EDGE sensor assembly.
1 = P_EDGE sensor assembly 2 = Screw (M2x12) fixing the P_EDGE sensor
assembly
Step 4 : Reinstall all parts in the opposite order of the removal procedure.
Step 5 : Perform media sensor sensitivity adjustment according to "Media sensor sensitivity adjustment".