User`s guide

User’s Guide Rockhopper 3 Extreme
CHAPTER 6 : PRINTER MENU
91 AP-75198– Rev. 1.2
6 .5.1.19 S h eetsizem enu
When loading a sheet of media, set the method for detecting the size of the media.
Setup items Parameters Description
SheetSize Auto Media measurement sequence REAR  RIGHT  LEFT  TOP
Length
Media measurement sequence RIGHT  LEFT  TOP
Media orientation when loading standard size media.
Width
Media measurement sequence RIGHT  LEFT  TOP
Media orientation when loading standard size media.
- After setting, shift to the previous hierarchy menu.
Notes
When using sheet media other than recommended media, set to "blank form vertical" or "blank form
horizontal".
The following size of sheet media can be set.
± ISO series (A0, A1, A2, A3, A4)
± JIS series (B1, B2, B3, B4)
± ARCH series (A, B, C, D)
6 .5.1.20 Top feedm enu
Set the amount of media to be fed when printing begins. Make this setting when using roll media.
Setup items Parameters Description
Top feed <0mm>-400mm To feed media at the start of printing. Set when
printing on roll media.
 [F2] key: to increase the setup value.
 [F4] key: to decrease the setup value.
 [ENTER] key: to confirm the setup value
 [CANCEL] key: to cancel the setup value