User`s guide

User’s Guide Rockhopper 3 Extreme
CHAPTER 6 : PRINTER MENU
89 AP-75198– Rev. 1.2
6 .5.1.13 P ostF ixerm enu
Set the temperature of the Post Fixer.
Setup items Parameters Description
Post Fixer OFF  50°C Change post fixer temperature by operating the following keys.
 [F2] key: to increase the setup value.
 [F4] key: to decrease the setup value.
 [ENTER] key: to confirm the setup value
 [CANCEL] key: to cancel the setup value
6 .5.1.14 D rierm enu
Set the temperature of the Drier.
Setup items Parameters Description
Drier OFF  50°C Change drier temperature by operating the following keys.
 [F2] key: to increase the setup value.
 [F4] key: to decrease the setup value.
 [ENTER] key: to confirm the setup value
 [CANCEL] key: to cancel the setup value
Notes
The default setting for the drier is set to 50°C.
The function of the drier (D): Heating the printed transfer paper evaporates the water fast enough so
that the print is touch-dry when wound.
6 .5.1.15 H S ta tusm enu
Check the temperature of the heating elements.
Notes
A stands for the Heater.
B stands for the Fixer.
C stands for the Post Fixer.
D stands for the Dryer.
Press the [CANCEL] key to go to the previous menu.