User`s guide

User’s Guide Rockhopper 3 Extreme
CHAPTER 6 : PRINTER MENU
87 AP-75198– Rev. 1.2
6 .5.1.7 Inkdrytim em enu
Set the waiting period between the end of operation and the start of next printing in order to let the printed
media dry.
Setup items Parameters Description
InkDryTime 0 to <30 sec. > to 270 sec. to 60 min. To change the InkDryTime by operating the
following keys.
 [F2] key: to increase the setup value.
 [F4] key: to decrease the setup value.
 [ENTER] key: to confirm the setup value
 [CANCEL] key: to cancel the setup value
6 .5.1.8 H ea dH eig h tm enu
Set the distance (head height) between the print head and the media.
Head height can be changed to three levels according to media thickness.
Setup items Parameters Description
HeadHeight Low When using media with a thickness of 80µm to 300µm
[Middle]
When using media with a thickness of 300µm to 700µm
High When using media with a thickness of 700µm to 1000µm
- (1 µm = 0,001 mm)
Notes
Set the height of the head in relation to the thickness of the media.
If the setting is set to "High" and the print is created on thin media, good quality print results will not be
achieved.
If the setting is set to "Low" and thick media is used, the media and print head will come into contact
and may result in damage to the product.
6 .5.1.9 Stiffnessm enu
Set the media sticking force (media stiffness) to the media guide.
Setup items Parameters Description
Stiff <Normal> Setting for normal media
Soft Setting for soft media where media feeding errors
and media jams occur
- After setting, shift to the previous hierarchy menu.