User`s guide

User’s Guide Rockhopper 3 Extreme
CHAPTER 6 : PRINTER MENU
84 AP-75198– Rev. 1.2
6 .5.1.3 Testprintm enu
Make test prints.
Setup items Parameters Description
Test print (1/2) SetupPrint Performs setup printing.
NozzleCheck Performs nozzle check printing.
Alignment (UniDir) Performs accuracy adjustment printing in one direction.
Alignment (BiDir) Performs accuracy adjustment printing in two directions.
Test print (2/2) Palette printing Performs palette printing.
Maintenance status Maintenance status printing is performed.
Distance Adj. Check Print distance adjustment check pattern
Test print (1/2-2/2) - [CANCEL] key: shift to the previous hierarchy menu.
6 .5.1.4 M edia setup m enu
Perform various settings for media.
Setup items Parameters Description
Media setting Type Sets the media type used for test printing.
Cut size To set the method for detecting the size of the media when sheet
media has been loaded.
Top feed Sets the amount of media to be fed when printing begins. Make this
setting when using roll media.
Media cutting The method of cutting the media after printing is set here.
- [CANCEL] key: to shift to the previous hierarchy menu.