User`s guide

User’s Guide Rockhopper 3 Extreme
CHAPTER 6 : PRINTER MENU
109 AP-75198– Rev. 1.2
6 .5.4.11 Rem P a nel
With this function it is possible to enable or disable remote control. This feature is for future use only! Leave
this setting to its default value, OFF!
6 .5.4.12 Rem oteconnection
This feature is for future use only! Leave this setting to its default value, OFF!
6 .5.4.13 La ng ua g e
With this function it is possible to select other languages. Currently only English is available
6 .5.4.14 C a pskip
CapSkip is enabled and a print job is finished, capin is postponed with about 15s, to allow a new printjob to
start immediately, without capin/capout cycle. Default value is OFF
6 .5.4.15 F ilem a na g em entsetup m enu
Make various settings for the processing method of the printing data sent from computer to the installed hard
disk in the printer.
Notes
The items on the File Management menu are displayed if a hard disk has been installed
Setup items Parameters Description
File management (1/2) Write mode To set writing method of printing data to the hard disk and printing
method.
Re-print Set this when you want to draw the printing data saved on the
hard disk.
Delete Set this when deleting the printing data saved on the hard disk.
Re-name To change file name of the printing data saved on the hard disk.
File management (2/2) Format To perform formatting of hard disk.
File management (1/2-
2/2)
-  [CANCEL] key: To shift to the previous hierarchy menu.