User`s guide

User’s Guide Rockhopper 3 Extreme
CHAPTER 6 : PRINTER MENU
108 AP-75198– Rev. 1.2
6 .5.4.8 A uto C lea ning M enu
In normal printing conditions, it is not recommended to use this function. When experiencing regular nozzle
loss, one of the three AutoCleaning features can be used.
When using this function, the wiping activity will be much higher, so be sure to securely perform your daily
and weekly maintenance.
Setup items Parameters Description
Auto Clean Waiting To perform a little, normal, powerful cleaning while printer is idle
for 1, 2, 3, 4, 5, 6, 9, 12, 18, 24 hours.
Printing To perform a little, normal, powerful cleaning after 5, 10, 15, 20,
30, 45, 60, 90, 120, 150,180 minutes of printing.
Before Printing To perform a little, normal, powerful a cleaning before every job
-  [CANCEL] key: to shift to the previous hierarchy menu.
6 .5.4.9 C a p C ycleM enu
Perform a TubingFlush every 1 to 24 hours.
Notes
A TubingFlush is automatically performed after 10 minutes of idle and before shut down of the printer.
Setup items Parameters Description
Cap Cycle
OFF
No tubing flush will be performed
1 - 24 hours Every 1  24 hours (adjustable) a TubingFlush is performed.
-  [CANCEL] key: To shift to the previous hierarchy menu.
6 .5.4.10 S la ntC h eckM enu
To enable or disable whether the printer performs a slant check after every print of at least 1 meter.
Setup items Parameters Description
SlantCheck Off No SlantCheck
On
Perform SlantCheck
Autocorrect When a slant check is performed with an auto correction, the
next print files are repositioned against the new media position.
This will improve the comfort level for unattended printing.
- [CANCEL] key: shift to the previous hierarchy menu.