User`s guide

User’s Guide Rockhopper 3 Extreme
CHAPTER 6 : PRINTER MENU
106 AP-75198– Rev. 1.2
6 .5.4.2 E rrorD ispla ym enu
To set display method to the operation panel when minor error occurred.
Setup items Parameters Description
ErrorDisplay <Off> No ErrorDisplay.
On To perform ErrorDisplay.
- To shift to the previous hierarchy menu.
6 .5.4.3 P a perdetection m enu
To perform detection of width and edge of the media, when media has been initialized
Setup items Parameters Description
media detect <Normal> To perform media detection automatically.
OFF No media detection.
Take-up mechanism Should be selected when using the winding system and media is
most right loaded.
RollFeed Should be selected when using the winding system and media is
centre loaded
-  [CANCEL] key: to shift to the previous hierarchy menu.
Notes
When setting "Take-up Mechanism" on the Media Detection menu, the following limits are applied to
the operation of the product.
± For initial media, only the media width is detected.
± Under normal conditions, media cannot be sent backward.
± The media cannot be moved forward or backward from the Origin Setting menu.
± The settings in the Media Cut menu are disabled, and the settings are changed to "Off". (Refer to
Media cut menu)
6 .5.4.4 O n clea ning m enu
Set when cleaning should be performed automatically when powering ON.
Setup items Parameters Description
Power on
cleaning
<Off> Power on cleaning is not performed.
Little
Power on cleaning is performed.
Normal
Powerful
- To shift to the previous hierarchy menu.