User`s guide

User’s Guide Rockhopper 3 Extreme
CHAPTER 6 : PRINTER MENU
100 AP-75198– Rev. 1.2
6 .5.2.14 O nlinetim eoutm enu
When sending data to the printer, it might be possible that the data transfer is interrupted. The printer will
wait, depending on the set online timer, to consider the data transfer as finished. The printer will print the
received data. It is recommended to disable (OFF) this feature. The printer will wait until the rest of the data
is received.
Setup items Parameters Description
OnlineTimer OFF/2sec - 800sec. To change the Online time out time by operating the
following keys.
 [F2] key: to increase the setup value.
 [F4] key: to decrease the setup value.
 [ENTER] key: to confirm the setup value
 [CANCEL] key: to cancel the setup value
6 .5.2.15 La youtsetup m enu
Make various settings on layout function.
Notes
The layout function automatically determines the size of printing data sent from the computer,
and then determines the amount of roll media required without wasting media.
If sheet media has been loaded, the layout function is disabled.
Setup items Parameters Description
Layout Joint Makes settings for stitching print.
CutPos. To set the media cutting position after printing has been completed.
- [CANCEL] key: To shift to the previous hierarchy menu.
6 .5.2.16 Jointprinting m enu
Set joint printing.
Setup items Parameters Description
Joint <Off> Does not perform stitching print.
On Performs stitching print
- - Shifts to the previous hierarchy menu.