Instruction manual

Operation Instructions Rockhopper 3 Extreme

CHAPTER 6: PRINTER MENU

AP-77150 – Rev. 2.0

6.3.2.2 [F2] - Cleaning

While printing, it could be possible that some nozzles drop out, in that case, perform a little, normal or

powerful cleaning.

Please follow the steps below to perform a cleaning.

When there are some missing nozzles, a cleaning should be done. Depending on the quantity of missing

nozzles and which head, a little, normal or powerful cleaning on head 1-2, head 3-4 or ALL could be done.

Step 1 : Press the [F2] key of the operation panel.

I) To shift to the cleaning menu.

Step 2 : Press the [F1] key or the [F2] key on the operation panel.

I) The product will perform following operations:

Setup items

Key name

Parameters

Description

Cut & Feed

ALL, Head 1 – Head 2

Clean ALL heads or head couple one or two

Little, normal, powerful

Set the intensity of a cleaning

Step 3 : Press the [ENTER] key to start the requested cleaning.

6.3.2.3 [F3] - Adjust heaters

While printing, the heater values can be changed. For example: when noticing cockling.

Please follow the steps below to adjust the heater temperatures.

Step 1 : Press the [F3] key

Step 2 : Following screen will be displayed

Step 3 : Change the value of one or more heaters or switch them all off.

Notes

For more details about heater adjustment, please refer to “Controlling the heater elements on the

Rockhopper 3 Extreme printer”