Instruction manual

Operation Instructions Rockhopper 3 Extreme
CHAPTER 6: PRINTER MENU
55
AP-77150 – Rev. 2.0
6.2.3.2 Activate/ deactivate heaters.
In the second menu, press the [F1] key to activate or deactivate all heating elements.
In case the heating elements are activated, the display will mention “SET OFF”. By pressing the [F4] key
you can deactivate the heating elements. The display will mention “SET ON”.
In case the heating elements are deactivated, the display will mention “SET ON”. By pressing the [F4] key
you can activate the heating elements. The display will mention “SET OFF”.
Please note that after finishing a printing job (and no other print job is sent to the printer the heating elements
will keep their temperature for approximately 6 minutes. After 6 minutes the heating elements are powered
OFF.
6.2.4 [F4] - Operating the pressure rollers
When you want to switch the up and down movement of the pressure rollers follow the steps below.
Step 1 : Press the [F4] key on the operation panel.
I) The printer works as follows.
Status of the printer
Operation after the [F4] key has been pressed
The pressure rollers have been lowered
The MEDIA SET lamp switches OFF.
The pressure rollers are lifted
The MEDIA SET lamp will turn on (orange).
The pressure rollers have been raised.
The MEDIA SET lamp switches ON (orange).
The pressure rollers are lowered.
The MEDIA SET lamp will turn off.
Notes
You can also switch the up and down movement of the pressure rollers using the foot switch instead of the
operation panel.
6.2.5 [ENTER] - Print mode check
Use the following procedure to check the print mode currently set.
Step 1 : Press the [ENTER] key on the operation panel.
I) The following information is displayed on the operation panel for three seconds.
Line 2
Line 3
Line 4
No.
Position
Description
Reference
1
Line 2
The printing quality is displayed.
Refer to ‘Printing quality menu’
2
Line 3
The interlace method is displayed.
Refer to ‘InterLace Setup menu’
3
Line 4
The printing direction is displayed.
Refer to ‘Printing direction menu’
Step 2 : When the printing mode display closes, the product changes to its main screen.