Instruction manual

Operation Instructions Rockhopper 3 Extreme
CHAPTER 6: PRINTER MENU
53
AP-77150 – Rev. 2.0
6.2 OPERATION PANEL IN STANDBY MODE
This section describes functions operated on the operational panel when the printer is in the normal status.
6.2.1 [F1] – Feeding, Cutting media and Step Adjust
When you want to feed media forward or backward, follow the steps below:
Step 1 : Verify the following regarding the condition of the printer.
I) It is not currently printing
Step 2 : Press the [F1] key of the operation panel.
I) To shift to the Cut&Feed menu.
Step 3 : Press the [F3] key or the [F4] key on the operation panel.
I) The product will perform following operations:
Setup items
Key name
Parameters
Description
Cut & Feed
F1
Cut
Cut media
F2
Dist.Adj.
Set step
F3
Forward
Feeds media forward.
F4
Backward
Feeds media backward.
Notes
If "Take-Up Roll" is set in the media detection setup menu, the product will not operate even if the [F4] key
has been pressed.
6.2.2 [F2] - Cleaning the heads
When there are some missing nozzles, a cleaning should be done. Depending on the quantity of missing
nozzles and which head, a little, normal or powerful cleaning on head 1-2, head 3-4 or ALL could be done.
Step 1 : Verify the following regarding the condition of the printer.
I) It is not currently printing