Instruction manual

Operation Instructions Rockhopper 3 Extreme
CHAPTER 4 : PERIODICAL MAINTENANCE
33
AP-77150 – Rev. 2.0
Monthly maintenance
4.1.2.1 Replacing the wipers
Step 1 : Power ON the printer and go to the “WiperClean-Menu”. This will cause the unlocking of the
carriage.
Step 2 : Slide the carriage to the left side of the machine.
Step 3 : Remove the old wipers with a pair of tweezers
Step 4 : Before inserting a new wiper, moisten the wiper with Eco-Solvent Ultra Cleaning Liquid.
Step 5 : Insert the moistened wiper with a pair of tweezers.
Be sure to insert the wiper
correctly as shown below:
When standing in front of
the machine.
Be sure that the wiper clicks in the wiper
holder!
Step 6 : Close the front cover and press the [ENTER] key. The head will cap in.
Notes
• Be careful not to break the lips of the wiper arm while installing the wipers.
• Do not touch the wipers with your bare hands to avoid fat or dirt get in contact with the wipers and
automatically the nozzle plate. Use a pair of tweezers to avoid this. Clean wipers with appropriate
cleaning liquid in case of dirt.